Modeling and schematics
Looking for schematics or helpful tips on modeling? This might be the place for you to share your ideas.
Re: Deck vent for Stern Driving Tank
Posted by:
Simon
()
Date: May 15, 2010 09:53PM
I am working on this area again I am currently correcting and adding more detail to the stern section. I found this picture below (from U-995 by E. Wetzel) you can see a dockworker install piping to the stern. Are these pipes the high pressure air lines to the driving tanks?
Or were the high pressure air lines a flexible or hard piping? As I though the high pressure air lines would be hard pipe? Although it would make more sense to used a flexible piping.
Or were the high pressure air lines a flexible or hard piping? As I though the high pressure air lines would be hard pipe? Although it would make more sense to used a flexible piping.