Modeling and schematics  
Looking for schematics or helpful tips on modeling? This might be the place for you to share your ideas. 
VIIC Bow Stringer III
Posted by: TopherVIIC ()
Date: December 16, 2011 11:38PM

Odd question of the day...
From a skeletal point of view, what does the Bow Stringer III reportedly located between "B" and "C" decks look like? Also, do the gusset plates in this section stretch hull wall to hull wall, or are they triangular and only ensure that the central longitudinal frame member remain vertical? Where, between decks "B" and "C" is this fitted? Was it above, in mid-line, or below the level of the oval limber holes that are between the tube doors?







Question mark II - does the collision bulkhead at the aft end of the chain locker at frame 101 go from keel up all the way to the bottom of Deck "E" (presumably with limber holes?) or is it just partial support/reenforcent for the fwd dive plane/skeg area?
OK - those are decent Friday questions!
Cheers!
Topher VIIC

Options: ReplyQuote


Subject Written By Posted
VIIC Bow Stringer III TopherVIIC 12/16/2011 11:38PM
Re: VIIC Bow Stringer III TopherVIIC 12/16/2011 11:51PM


Your Name: 
Subject: 
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically.
       **  **     **  **    **  **         **     ** 
       **  **     **  **   **   **    **   **     ** 
       **  **     **  **  **    **    **   **     ** 
       **  *********  *****     **    **   **     ** 
 **    **  **     **  **  **    *********   **   **  
 **    **  **     **  **   **         **     ** **   
  ******   **     **  **    **        **      ***