General Discussions
This is the place to discuss general issues related to the U-boat war or the war at sea in WWII.
Re: Pressure hull and outer skin thickness of U-boats.
Posted by:
SnakeDoc
()
Date: September 29, 2010 06:38AM
Hello
rovarch Wrote:
-------------------------------------------------------
> I am new to this site. I am writing a paper about
> U-boat wreck sites and the site formation
> processes. I am trying to find out how thick the
> pressure hull and outer skin metal was on Type
> VIIC, Type VIIC/41 and a WWI Mittel U?
For type VIIC hull thickness you can find in the following report:
[uboatarchive.net] (page 37).
The thikness of outer shell for type IXC (I think there were no
significant differences in construction of outer shell between
type IX and type VII - compare pressure hulls) can be found here:
[uboatarchive.net]
(section S11 - HULL STRUCTURAL, 3. Outer shell)
Type VIIC/41 had pressure hull plating 21 mm thick (comparing to
18,5 mm for type VIIC).
--
Regards
Maciek
[www.tvre.org]
rovarch Wrote:
-------------------------------------------------------
> I am new to this site. I am writing a paper about
> U-boat wreck sites and the site formation
> processes. I am trying to find out how thick the
> pressure hull and outer skin metal was on Type
> VIIC, Type VIIC/41 and a WWI Mittel U?
For type VIIC hull thickness you can find in the following report:
[uboatarchive.net] (page 37).
The thikness of outer shell for type IXC (I think there were no
significant differences in construction of outer shell between
type IX and type VII - compare pressure hulls) can be found here:
[uboatarchive.net]
(section S11 - HULL STRUCTURAL, 3. Outer shell)
Type VIIC/41 had pressure hull plating 21 mm thick (comparing to
18,5 mm for type VIIC).
--
Regards
Maciek
[www.tvre.org]
Subject | Written By | Posted |
---|---|---|
Pressure hull and outer skin thickness of U-boats. | rovarch | 09/28/2010 04:54PM |
Re: Pressure hull and outer skin thickness of U-boats. | Ken Dunn | 09/28/2010 08:22PM |
Re: Pressure hull and outer skin thickness of U-boats. | rovarch | 09/29/2010 10:46AM |
Re: Pressure hull and outer skin thickness of U-boats. | Ken Dunn | 09/29/2010 03:06PM |
Re: Pressure hull and outer skin thickness of U-boats. | SnakeDoc | 09/29/2010 06:38AM |
Re: Pressure hull and outer skin thickness of U-boats. | rovarch | 09/29/2010 10:49AM |
Re: Pressure hull and outer skin thickness of U-boats. | Jack Hrovatin | 07/13/2016 12:10AM |