Modeling and schematics
Looking for schematics or helpful tips on modeling? This might be the place for you to share your ideas.
Re: First snaffu: variant limber hole patterns aro
Posted by:
Einsamer Wolf
()
Date: December 02, 2002 04:18AM
I agree that before I do anything, I have to select a U-Boat. THat is probably going to be u-96, unless u-99 has a cool emblem too. I agree with you that if I do this at all, I should either choose play 2b or 2c. I think plan 2c would be the easist. Just fill one of the rows, then lower the second torpedo tube a little. Anyhow, #2a is pretty muich out. In addition to the slippage issue, the putty wont hold up against that large of an area.
I may not have to do this at all. But since the U boat I am leaning towards most is Type VII C, will probably have to do this. That is why I am thinking about it now.
Best Wishes,
Einsamer Wolf
I may not have to do this at all. But since the U boat I am leaning towards most is Type VII C, will probably have to do this. That is why I am thinking about it now.
Best Wishes,
Einsamer Wolf
Subject | Written By | Posted |
---|---|---|
First snaffu: variant limber hole patterns around | Einsamer Wolf | 12/01/2002 05:44PM |
Re: First snaffu: variant limber hole patterns aro | Wiljan | 12/01/2002 09:08PM |
Re: First snaffu: variant limber hole patterns aro | joe brandt | 12/02/2002 03:20AM |
Re: First snaffu: variant limber hole patterns aro | Einsamer Wolf | 12/02/2002 04:18AM |
Re: First snaffu: variant limber hole patterns aro | J.Brennan | 12/02/2002 04:18AM |
Re: First snaffu: variant limber hole patterns aro | Einsamer Wolf | 12/02/2002 05:01AM |
Your IP address, domain or ISP has been blocked. Please contact the forum administrators.