Modeling and schematics
Looking for schematics or helpful tips on modeling? This might be the place for you to share your ideas.
Re: Turning a brass barrel for the deck gun
Posted by:
J.Brennan
()
Date: December 06, 2002 03:32AM
Hello Wolf
A mini-hobby lathe is the proper way to do this job in turning round brass rods.
However, as suggested before you can get brass tubes in many different sizes at your local hobby shop.... that may have the stuff in stock?
If you get problems in getting this material ..sent me an email?
cheers, Joe Brennan
A mini-hobby lathe is the proper way to do this job in turning round brass rods.
However, as suggested before you can get brass tubes in many different sizes at your local hobby shop.... that may have the stuff in stock?
If you get problems in getting this material ..sent me an email?
cheers, Joe Brennan
Subject | Written By | Posted |
---|---|---|
Turning a brass barrel for the deck gun | Einsamer Wolf | 12/05/2002 02:14PM |
Re: Turning a brass barrel for the deck gun | joe brandt | 12/06/2002 02:08AM |
Re: Turning a brass barrel for the deck gun | J.Brennan | 12/06/2002 03:32AM |
Re: Turning a brass barrel for the deck gun | Einsamer Wolf | 12/06/2002 06:40AM |
Re: Turning a brass barrel for the deck gun | joe brandt | 12/06/2002 08:50PM |
Re: Turning a brass barrel for the deck gun | J.Brennan | 12/06/2002 09:02PM |
Re: Turning a 8.8 cm gun barrel | Charla Anaya | 12/08/2002 12:35AM |