Modeling and schematics
Looking for schematics or helpful tips on modeling? This might be the place for you to share your ideas.
Re: Turning a brass barrel for the deck gun
Posted by:
J.Brennan
()
Date: December 06, 2002 09:02PM
Wolf &Others
A drilling machine can be used to sand down the round gun barrel, after some putty & other materials are used to make this slope on this gun model..eg 88mm.
Cheers Joe Brennan
A drilling machine can be used to sand down the round gun barrel, after some putty & other materials are used to make this slope on this gun model..eg 88mm.
Cheers Joe Brennan
Subject | Written By | Posted |
---|---|---|
Turning a brass barrel for the deck gun | Einsamer Wolf | 12/05/2002 02:14PM |
Re: Turning a brass barrel for the deck gun | joe brandt | 12/06/2002 02:08AM |
Re: Turning a brass barrel for the deck gun | J.Brennan | 12/06/2002 03:32AM |
Re: Turning a brass barrel for the deck gun | Einsamer Wolf | 12/06/2002 06:40AM |
Re: Turning a brass barrel for the deck gun | joe brandt | 12/06/2002 08:50PM |
Re: Turning a brass barrel for the deck gun | J.Brennan | 12/06/2002 09:02PM |
Re: Turning a 8.8 cm gun barrel | Charla Anaya | 12/08/2002 12:35AM |