Modeling and schematics
Looking for schematics or helpful tips on modeling? This might be the place for you to share your ideas.
Revell Type VII
Posted by:
Mark Proulx
()
Date: September 20, 2020 04:05PM
I'm a new member here and this is my first post. I look forward to learning from the group, so please go easy on me...
At the moment, I am drilling the holes on the hull of the Revell Type VII in 72nd scale. Above the saddle tank, is the large slot in the hull. My question is, would it be appropriate to see all the way thru that gap to the opening on the other side or is the pressure hull blocking that line of sight. I understand that you won't see thru below the conning tower or hatch locations, but where else?
Thanks for any help you can provide...
Mark Proulx
At the moment, I am drilling the holes on the hull of the Revell Type VII in 72nd scale. Above the saddle tank, is the large slot in the hull. My question is, would it be appropriate to see all the way thru that gap to the opening on the other side or is the pressure hull blocking that line of sight. I understand that you won't see thru below the conning tower or hatch locations, but where else?
Thanks for any help you can provide...
Mark Proulx
Subject | Written By | Posted |
---|---|---|
Revell Type VII | Mark Proulx | 09/20/2020 04:05PM |
Re: Revell Type VII | Rollan | 05/05/2021 05:42AM |