Technology and Operations
This forum is for discussing technological & operational matters pertaining to U-boats.
Re: Pressure hull construction - VIIC boats
Posted by:
ROBERT M.
()
Date: November 09, 2002 05:01AM
Hi Rainer:
In the diameter of the pressure hull, I placed the decimal in the wrong place, sorry.
But, what's the difference between 1.85cm and 18.5mm? I'm not too good with the Metric System.
Source for my post is: "TYPE VII U-boats" by Robert C. Stern, originally published
in 1991 and reprinted in 2002, by the BROCKHAMPTON PRESS, LONDON, top of
page 31. The references for the book are listed on page 156.
Regards,
ROBERT M.
In the diameter of the pressure hull, I placed the decimal in the wrong place, sorry.
But, what's the difference between 1.85cm and 18.5mm? I'm not too good with the Metric System.
Source for my post is: "TYPE VII U-boats" by Robert C. Stern, originally published
in 1991 and reprinted in 2002, by the BROCKHAMPTON PRESS, LONDON, top of
page 31. The references for the book are listed on page 156.
Regards,
ROBERT M.