Technology and Operations  
This forum is for discussing technological & operational matters pertaining to U-boats. 
Re: Low Pressure (Exhaust Gas) Blow System
Posted by: Simon ()
Date: November 04, 2011 03:14AM

Exhaust Gas Blowing System

The exhaust gas blow system used exhaust gas from the main engines to assist with blowing the tanks to raise the U-boat. A pipe extending forward from the main engine exhaust valves, to led forward to a manifold located over the control room. From the manifold, smaller pipes runs to 8 tanks around the u-boat. The eight associated valves in the manifold were operable from within the control room.


Fig. 1. A overview of the piping on the stern section of a Type VIIC with a schnorchel.


Fig. 2. A overview of the piping around the tower, the manifold can be seen lower right.


Fig. 3. Close-up view of the manifold and the 8 smaller pipes that led to the different tanks.


Fig. 4. Close-up view of piping about the air inlet for the main engines.

Options: ReplyQuote


Subject Written By Posted
Low Pressure (Exhaust Gas) Blow System Scott Sorenson 10/17/2006 02:03AM
Re: Low Pressure (Exhaust Gas) Blow System ROBERT M. 10/17/2006 02:55AM
Re: Low Pressure (Exhaust Gas) Blow System Simon 10/27/2011 01:45AM
Re: Low Pressure (Exhaust Gas) Blow System Simon 11/04/2011 03:14AM
Re: Low Pressure (Exhaust Gas) Blow System Ã…kerberg 10/27/2011 08:12AM


Your Name: 
Your Email: 
Subject: 
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically.
  *******    *******   **      **  **    **        ** 
 **     **  **     **  **  **  **  ***   **        ** 
 **                **  **  **  **  ****  **        ** 
 ********    *******   **  **  **  ** ** **        ** 
 **     **         **  **  **  **  **  ****  **    ** 
 **     **  **     **  **  **  **  **   ***  **    ** 
  *******    *******    ***  ***   **    **   ******