Re: Bearing material used on propellor shaft strut and hull bearings
Posted by: ROBERT M. ()
Date: December 08, 2009 09:53PM

Funkmeister, et al:

Thanks for the following url: http:/www.u-boatarchive.netDesignStudiesUSHands.htm


I was scanning the U-3008 section and found the following statement: "The shaft bearings are inlaid with either lignum vitae or a type of phenolic material. When
the former is used, the lower 1/3 of the bearing is with end-grained wood and the
upper 2/3 is with flat-grained wood."

Regards,

ROBERT M.



Subject Written By Posted
Bearing material used on propellor shaft strut and hull bearings ROBERT M. 10/25/2009 09:42PM
Re: Bearing material used on propellor shaft strut and hull bearings Funkmeister 10/31/2009 09:47PM
Re: Bearing material used on propellor shaft strut and hull bearings ROBERT M. 11/01/2009 08:07PM
Re: Bearing material used on propellor shaft strut and hull bearings majid 12/03/2009 04:57AM
Re: Bearing material used on propellor shaft strut and hull bearings ROBERT M. 12/03/2009 05:06AM
Re: Bearing material used on propellor shaft strut and hull bearings ROBERT M. 12/08/2009 09:53PM