Technology and Operations
This forum is for discussing technological & operational matters pertaining to U-boats.
Re: Bearing material used on propellor shaft strut and hull bearings
Posted by:
ROBERT M.
()
Date: December 08, 2009 09:53PM
Funkmeister, et al:
Thanks for the following url: http:/www.u-boatarchive.netDesignStudiesUSHands.htm
I was scanning the U-3008 section and found the following statement: "The shaft bearings are inlaid with either lignum vitae or a type of phenolic material. When
the former is used, the lower 1/3 of the bearing is with end-grained wood and the
upper 2/3 is with flat-grained wood."
Regards,
ROBERT M.
Thanks for the following url: http:/www.u-boatarchive.netDesignStudiesUSHands.htm
I was scanning the U-3008 section and found the following statement: "The shaft bearings are inlaid with either lignum vitae or a type of phenolic material. When
the former is used, the lower 1/3 of the bearing is with end-grained wood and the
upper 2/3 is with flat-grained wood."
Regards,
ROBERT M.
Subject | Written By | Posted |
---|---|---|
Bearing material used on propellor shaft strut and hull bearings | ROBERT M. | 10/25/2009 09:42PM |
Re: Bearing material used on propellor shaft strut and hull bearings | Funkmeister | 10/31/2009 09:47PM |
Re: Bearing material used on propellor shaft strut and hull bearings | ROBERT M. | 11/01/2009 08:07PM |
Re: Bearing material used on propellor shaft strut and hull bearings | majid | 12/03/2009 04:57AM |
Re: Bearing material used on propellor shaft strut and hull bearings | ROBERT M. | 12/03/2009 05:06AM |
Re: Bearing material used on propellor shaft strut and hull bearings | ROBERT M. | 12/08/2009 09:53PM |