Technology and Operations  
This forum is for discussing technological & operational matters pertaining to U-boats. 
Go to: Forum List•Message List•New Topic•Search•Log In•Print View
Re: Bearing material used on propellor shaft strut and hull bearings
Posted by: ROBERT M. ()
Date: December 08, 2009 09:53PM

Funkmeister, et al:

Thanks for the following url: http:/www.u-boatarchive.netDesignStudiesUSHands.htm


I was scanning the U-3008 section and found the following statement: "The shaft bearings are inlaid with either lignum vitae or a type of phenolic material. When
the former is used, the lower 1/3 of the bearing is with end-grained wood and the
upper 2/3 is with flat-grained wood."

Regards,

ROBERT M.

Options: Reply•Quote


Subject Written By Posted
Bearing material used on propellor shaft strut and hull bearings ROBERT M. 10/25/2009 09:42PM
Re: Bearing material used on propellor shaft strut and hull bearings Funkmeister 10/31/2009 09:47PM
Re: Bearing material used on propellor shaft strut and hull bearings ROBERT M. 11/01/2009 08:07PM
Re: Bearing material used on propellor shaft strut and hull bearings majid 12/03/2009 04:57AM
Re: Bearing material used on propellor shaft strut and hull bearings ROBERT M. 12/03/2009 05:06AM
Re: Bearing material used on propellor shaft strut and hull bearings ROBERT M. 12/08/2009 09:53PM


Go to: Forum List•Message List•Search•Log In
Your Name: 
Subject: 
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically.
 **      **  **    **        **  **     **  ******** 
 **  **  **  ***   **        **   **   **      **    
 **  **  **  ****  **        **    ** **       **    
 **  **  **  ** ** **        **     ***        **    
 **  **  **  **  ****  **    **    ** **       **    
 **  **  **  **   ***  **    **   **   **      **    
  ***  ***   **    **   ******   **     **     **