Re: Modelling Pressure Hull for Revell VII
Posted by:
Ian
()
Date: October 12, 2006 11:55PM
After some serious googling I've now found an answer that doesn't involve Yankee Modelworks pressure hull kit.
Have a look at this site [www.salt6.com].
With a little imagination the top half of the pressure hull can be built from styrene. Any othere details can be added with some sprue.
Have a look at this site [www.salt6.com].
With a little imagination the top half of the pressure hull can be built from styrene. Any othere details can be added with some sprue.
| Subject | Written By | Posted |
|---|---|---|
Modelling Pressure Hull for Revell VII
|
Ian | 10/12/2006 03:19PM |
|
Re: Modelling Pressure Hull for Revell VII
|
Ian | 10/12/2006 11:55PM |
|
Re: Modelling Pressure Hull for Revell VII
|
rokket | 10/15/2006 02:02AM |
|
Re: Modelling Pressure Hull for Revell VII
|
Bill | 10/15/2006 03:31PM |
|
Re: Modelling Pressure Hull for Revell VII
|
Rokket | 10/17/2006 11:40AM |
|
Re: Modelling Pressure Hull for Revell VII
|
Ian | 10/19/2006 01:04PM |
|
Re: Modelling Pressure Hull for Revell VII
|
Ian | 10/19/2006 01:33PM |
|
Re: Modelling Pressure Hull for Revell VII
|
David French-Wollen | 11/07/2006 08:46PM |
|
Re: Modelling Pressure Hull for Revell VII
|
Glenn Cauley | 06/26/2008 12:32PM |
|
Re: Modelling Pressure Hull for Revell VII
|
sara | 11/16/2013 09:18PM |
|
Re: Modelling Pressure Hull for Revell VII
|
Capt Kremin | 11/17/2013 07:37AM |