General Discussions
This is the place to discuss general issues related to the U-boat war or the war at sea in WWII.
Re: Small Calibre guns penetrating pressure hull?
Posted by:
ThomasHorton
()
Date: April 27, 2011 02:14PM
The pressure hull of a Type VIIC was .88 inches thick
[uboatarchive.net] Page 37
The penetration of the .50 round is dependent on the range as well as a multitude of other factors.
At 200 meters the .50 M2 Ap round can penetrate .9 inches of hardened armour
At 600 Meters the same round can penetrate .5 inches of hardened armour
[www.inetres.com] scroll to the bottom
So whether a .50 cal could damage a submarine would depend on the range and how many rounds impacted at a specific point.
The angle of impact would have a very large effect on armour penetration
The Hispano 20MM round (1942) seems to have a armour penetration of about .87 inches
[www.wwiiequipment.com]
Again range and impact angle will affect these figures.
I hope this helped out a little
[uboatarchive.net] Page 37
The penetration of the .50 round is dependent on the range as well as a multitude of other factors.
At 200 meters the .50 M2 Ap round can penetrate .9 inches of hardened armour
At 600 Meters the same round can penetrate .5 inches of hardened armour
[www.inetres.com] scroll to the bottom
So whether a .50 cal could damage a submarine would depend on the range and how many rounds impacted at a specific point.
The angle of impact would have a very large effect on armour penetration
The Hispano 20MM round (1942) seems to have a armour penetration of about .87 inches
[www.wwiiequipment.com]
Again range and impact angle will affect these figures.
I hope this helped out a little
Subject | Written By | Posted |
---|---|---|
Small Calibre guns penetrating pressure hull? | Simon D | 04/27/2011 10:56AM |
Re: Small Calibre guns penetrating pressure hull? | ThomasHorton | 04/27/2011 02:14PM |
Re: Small Calibre guns penetrating pressure hull? | Ken Dunn | 04/27/2011 04:14PM |
Re: Small Calibre guns penetrating pressure hull? | Simon D | 04/27/2011 10:49PM |