Modeling and schematics  
Looking for schematics or helpful tips on modeling? This might be the place for you to share your ideas. 
Go to: Forum List•Message List•New Topic•Search•Log In•Print View
About to install the Yankee Pressure hull
Posted by: Einsamer Wolf ()
Date: January 25, 2006 03:00AM

SALUT!

I am slowly working away on my u-boat. I am installing the shelves to the Yankee pressure hull. I may be able to glue the two halves by the end of this weekend. Anyway, I vaguely recall that one must drill into the center piece to accomodate for the periscope shafts and periscopes, and that it is quite tricky to fit the center piece to accomodate the tower and periscopes. Any advice? Would it not suffice to cut the lower half of the shaft that extends below the tower? Also I have reserved CMK exterior set 1, and possibly two, to obtain a correct attack periscope base and UZO mount. How will this affect things?

Thanks in advance,

EW

Options: Reply•Quote


Subject Written By Posted
About to install the Yankee Pressure hull Einsamer Wolf 01/25/2006 03:00AM
Re: About to install the Yankee Pressure hull Jess 01/25/2006 06:19AM
Re: About to install the Yankee Pressure hull Einsamer Wolf 01/25/2006 03:52PM
Re: About to install the Yankee Pressure hull Jess 01/26/2006 01:58AM


Go to: Forum List•Message List•Search•Log In
Your Name: 
Your Email: 
Subject: 
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically.
 **      **  **    **  **     **  **    **   ******  
 **  **  **  **   **   ***   ***  ***   **  **    ** 
 **  **  **  **  **    **** ****  ****  **  **       
 **  **  **  *****     ** *** **  ** ** **  **       
 **  **  **  **  **    **     **  **  ****  **       
 **  **  **  **   **   **     **  **   ***  **    ** 
  ***  ***   **    **  **     **  **    **   ******