Modeling and schematics
Looking for schematics or helpful tips on modeling? This might be the place for you to share your ideas.
Re: About to install the Yankee Pressure hull
Posted by:
Jess
()
Date: January 26, 2006 01:58AM
Right. If you're scratch building your scope housings, you're probably going to cut those shafts off anyway. So, no need to drill holes. However, you'll want to put something in place of the sky scope "sheath". It was outside of the water tight conning tower and could be seen through the main free flood vent.
You're right about not seeing much. But I like knowing that it's there and not having to build one. Although my next boat, I may build one myself.
Take Care,
Jess
You're right about not seeing much. But I like knowing that it's there and not having to build one. Although my next boat, I may build one myself.
Take Care,
Jess
Subject | Written By | Posted |
---|---|---|
About to install the Yankee Pressure hull | Einsamer Wolf | 01/25/2006 03:00AM |
Re: About to install the Yankee Pressure hull | Jess | 01/25/2006 06:19AM |
Re: About to install the Yankee Pressure hull | Einsamer Wolf | 01/25/2006 03:52PM |
Re: About to install the Yankee Pressure hull | Jess | 01/26/2006 01:58AM |