Modeling and schematics  
Looking for schematics or helpful tips on modeling? This might be the place for you to share your ideas. 
Go to: Forum List•Message List•New Topic•Search•Log In•Print View
Re: About to install the Yankee Pressure hull
Posted by: Jess ()
Date: January 25, 2006 06:19AM

Hi Einsmer,

What is the CMK exterior set? Haven't heard of it.

I scratchbuild my scope housings and just cut the shafts off and not worry about lining everything up. I can imagine it will be pretty tricky. I know my pressure hull didn't quite line up. You may have to sand one of the sides of the hull piece til it lines up.

You should still be able to put the two hull halves together, drop the pressure hull piece in place, then put you mid-section deck on and eyeball it that way.

Take Care,

Jess

Options: Reply•Quote


Subject Written By Posted
About to install the Yankee Pressure hull Einsamer Wolf 01/25/2006 03:00AM
Re: About to install the Yankee Pressure hull Jess 01/25/2006 06:19AM
Re: About to install the Yankee Pressure hull Einsamer Wolf 01/25/2006 03:52PM
Re: About to install the Yankee Pressure hull Jess 01/26/2006 01:58AM


Go to: Forum List•Message List•Search•Log In
Your Name: 
Your Email: 
Subject: 
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically.
 ********   ********  ********  ********    ******   
 **     **  **    **     **     **     **  **    **  
 **     **      **       **     **     **  **        
 ********      **        **     ********   **   **** 
 **     **    **         **     **     **  **    **  
 **     **    **         **     **     **  **    **  
 ********     **         **     ********    ******