Technology and Operations
This forum is for discussing technological & operational matters pertaining to U-boats.
Re: Torpedo running
Posted by:
SnakeDoc
()
Date: June 27, 2012 08:50PM
Hi
In the document "Torpedo G7e Bedienungsvorschrift" there is a chapter
"Versager beim Schießen und deren Ursachen" (Torpedo launch failure and causes)
and it says:
"C. Torpedo läuft nicht, bleibt vor dem Rohr liegen und treibt
1. Toter Mann, Öffnungshebel nicht gelegt, schwergängig oder
wieder nach vorn geschlagen, Laufstrecke nicht eingestellt.
2. Kurzschluß im Torpedo, Sicherung durchgebrannt.
3. Batterieumschalter steht auf Stellung "L" oder Kontaktflächen
sind oxydiert.
4. Batteriekabel nicht angeschlossen.
5. Luftgefäße nicht, oder nicht voll gefüllt."
"C. Torpedo not running, remains just front of the tube and drifts
1. Dead man, starting lever not pulled, hardly moving or even not
put initialy in the forward position, running distance not set.
2. short-circuit in torpedo installation, safety fuse burned out.
3. Battery switch in the position "L" (charging) or contacts
oxidized.
4. Battery power cable not connected.
5. Compressed aif flask not charged or not charged fully."
--
Regards
Maciek
[www.tvre.org]
In the document "Torpedo G7e Bedienungsvorschrift" there is a chapter
"Versager beim Schießen und deren Ursachen" (Torpedo launch failure and causes)
and it says:
"C. Torpedo läuft nicht, bleibt vor dem Rohr liegen und treibt
1. Toter Mann, Öffnungshebel nicht gelegt, schwergängig oder
wieder nach vorn geschlagen, Laufstrecke nicht eingestellt.
2. Kurzschluß im Torpedo, Sicherung durchgebrannt.
3. Batterieumschalter steht auf Stellung "L" oder Kontaktflächen
sind oxydiert.
4. Batteriekabel nicht angeschlossen.
5. Luftgefäße nicht, oder nicht voll gefüllt."
"C. Torpedo not running, remains just front of the tube and drifts
1. Dead man, starting lever not pulled, hardly moving or even not
put initialy in the forward position, running distance not set.
2. short-circuit in torpedo installation, safety fuse burned out.
3. Battery switch in the position "L" (charging) or contacts
oxidized.
4. Battery power cable not connected.
5. Compressed aif flask not charged or not charged fully."
--
Regards
Maciek

[www.tvre.org]
Subject | Written By | Posted |
---|---|---|
![]() |
SkipperBill | 06/05/2012 07:59PM |
![]() |
SnakeDoc | 06/06/2012 09:30AM |
![]() |
bill | 06/06/2012 09:38PM |
![]() |
SnakeDoc | 06/10/2012 07:24PM |
![]() |
bill | 06/11/2012 01:21PM |
![]() |
radiogaga80 | 06/14/2012 05:17PM |
![]() |
bill | 06/16/2012 07:14PM |
![]() |
radiogaga80 | 06/19/2012 03:55PM |
![]() |
SnakeDoc | 06/20/2012 09:04AM |
![]() |
SnakeDoc | 06/20/2012 08:54AM |
![]() |
Natter | 03/05/2013 11:15PM |
![]() |
SnakeDoc | 06/20/2012 08:50AM |
![]() |
bill | 06/20/2012 05:13PM |
![]() |
SnakeDoc | 06/27/2012 08:50PM |
![]() |
bill | 06/27/2012 10:08PM |
![]() |
Natter | 03/05/2013 11:07PM |