Modeling and schematics
Looking for schematics or helpful tips on modeling? This might be the place for you to share your ideas.
Re: Turning a brass barrel for the deck gun
Posted by:
Einsamer Wolf
()
Date: December 06, 2002 06:40AM
One thing--depending on the depiction, the barrel of the gun has a sloped contour, in that it gets narrower as you approach the the end of the barrel. The drawing I have shows that the fronthalf of the barrel is sloped. But Herne model. as well as other renditions, show a sloped contour extending throughout the length of the barrel. I bought a brass tube that should work. If I am unable to figure out how to replciate that sloped contour, I will use the resin piece that is sloped, and replace thje front portion with a brass tube.
THanks for All Your Guidance..
EW
THanks for All Your Guidance..
EW
Subject | Written By | Posted |
---|---|---|
Turning a brass barrel for the deck gun | Einsamer Wolf | 12/05/2002 02:14PM |
Re: Turning a brass barrel for the deck gun | joe brandt | 12/06/2002 02:08AM |
Re: Turning a brass barrel for the deck gun | J.Brennan | 12/06/2002 03:32AM |
Re: Turning a brass barrel for the deck gun | Einsamer Wolf | 12/06/2002 06:40AM |
Re: Turning a brass barrel for the deck gun | joe brandt | 12/06/2002 08:50PM |
Re: Turning a brass barrel for the deck gun | J.Brennan | 12/06/2002 09:02PM |
Re: Turning a 8.8 cm gun barrel | Charla Anaya | 12/08/2002 12:35AM |