Technology and Operations
This forum is for discussing technological & operational matters pertaining to U-boats.
Re: Hull Thickness
Posted by:
Rainer Bruns
()
Date: February 26, 2003 02:37AM
Hi Wayne,
Pressure vessel thickness on both VIIc and IXc etc was 18.5mm
(only planned type VIIc/42 was to have 25mm plate thickness, but none were built). Don't recall any case of penetration by A/C mach gun fire.
A small hole like that could be patched temporarily during a shallow dive from the inside by use of conventional braces etc if in an accessible location. Once the air was clear again, a doubler could be patch welded over the hole from the outside. Small steel pieces and welding equipment were aboard. Rgds, RB
Pressure vessel thickness on both VIIc and IXc etc was 18.5mm
(only planned type VIIc/42 was to have 25mm plate thickness, but none were built). Don't recall any case of penetration by A/C mach gun fire.
A small hole like that could be patched temporarily during a shallow dive from the inside by use of conventional braces etc if in an accessible location. Once the air was clear again, a doubler could be patch welded over the hole from the outside. Small steel pieces and welding equipment were aboard. Rgds, RB
Subject | Written By | Posted |
---|---|---|
Hull Thickness | Wayne Hendrix | 02/26/2003 12:20AM |
Re: Hull Thickness | Rainer Bruns | 02/26/2003 02:37AM |
Re: Hull Thickness | ROBERT M. | 02/26/2003 03:43AM |
Re: Hull Thickness | Rainer Bruns | 02/26/2003 04:40AM |
Re: Hull Thickness | ROBERT M. | 02/27/2003 11:21PM |
Re: Hull Thickness | Rainer Bruns | 02/28/2003 01:17AM |
Re: Hull Thickness | ROBERT M. | 03/01/2003 01:38AM |
Re: Hull Thickness | Rainer Bruns | 03/01/2003 04:02AM |
Re: Hull Thickness | ROBERT M. | 03/01/2003 05:16AM |
Re: Hull Thickness | Scott | 02/26/2003 08:58PM |
Re: Hull Thickness | Rainer Bruns | 02/27/2003 03:13AM |
Re: Hull Thickness | Scott | 02/27/2003 07:54PM |
Re: Hull Thickness | Rainer Bruns | 02/27/2003 09:40PM |
Re: Hull Thickness | ROBERT M. | 02/27/2003 10:26PM |
Re: Hull Thickness | Rainer Bruns | 02/28/2003 01:08AM |
Re: Hull Thickness | Scott | 02/28/2003 07:40PM |